Ferplast

BlLUSKIMMER is quick and easy to install:

 1. position the product inside the tank, taking care to ensure that the intake and outlet grilles are not close to elements that could in any way limit the suction or flow capacity; the magnet outside the tank allows the product to be fixed safely;

2. the collection tank must always remain above the water level;

3. the silencer must always remain outside the tank (to fix it use the special sucker);

4. adjust the vertical position of the skimmer using the magnet outside the tank and lining up the water level with the recommended level "water level" shown on the product;

5. connect the product to the mains;

6. for the first installation, the skimmer needs about 24-48 hours to reach its operating balance;

7. if at first you notice excess foam production, reduce the air flow using the regulator on the silencer; only later should you try to increase the air flow, returning, if possible, to the maximum level;

8. once it is fully operating, you can make small adjustments to the foam production by moving the skimmer vertically (with a total maximum range of about 1 cm) downwards if there is too little foam produced or if the foam is too dry and upwards if too much foam is produced or it is too wet;

9. for prolonged absences, you can connect a pipe to the excess dirt nozzle (after removing the plug), in order to allow discharge into a container outside the tank.

• Bluskimmer fitting